tag:blogger.com,1999:blog-3244768274591767827.post8931569496155622464..comments2024-03-28T00:34:07.978-07:00Comments on Jilliene Designing: Comprehensive overview of the Cricut Lite Cartridge "Chore Chart"Jilliene Designshttp://www.blogger.com/profile/01634260991789944604noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-3244768274591767827.post-40524166039390312012012-07-17T14:39:34.110-07:002012-07-17T14:39:34.110-07:00When I used the interface on my expression, I spen...When I used the interface on my expression, I spent a bunch of time dropping the size down in .25 inch increments until it reached a size that the machine would accept. This was a year ago, and I'm so sorry, I don't recall what the exact setting ended up being. However, I went to Cricut Craft Room today to see what would work and this is what I got:<br /> 1) change the orientation of the image so it is vertical rather than horizontal. This will make the width of the table run with the the 24 inch stretch of the mat.<br /> 2) Set your x and y axis to .5 x.5 so you are within the cut margin.<br /> 3)set your width to 11 and the height to 18.49.<br />This should work. <br /><br />I have to say that I was a little disappointed that the scale of the chart did not take up the entire width of the 24 inch(say 23 inch to account for the cut margins) mat when the height was set to 12 (actually 11). It would be nice to take full advantage of the mat potential.Jilliene Designshttps://www.blogger.com/profile/01634260991789944604noreply@blogger.comtag:blogger.com,1999:blog-3244768274591767827.post-58968691929770857172012-07-17T12:39:59.493-07:002012-07-17T12:39:59.493-07:00When you cut your "chart" on the 12x24 m...When you cut your "chart" on the 12x24 matt, what size did you set the dial to?Anonymousnoreply@blogger.com